 |
|||
|
|
|||
|
Page Title:
ENGINE REAR MOUNT PAD REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0025 00
ENGINE REAR MOUNT PAD REPLACEMENT (Contd)
REMOVAL
NOTE
Perform step 1 for engine left rear mount.
1.
Remove nut (1) and accelerator linkage (3) from throttle control lever (2).
NOTE
Right and left engine rear mounts are removed the same way.
This procedure covers the right engine rear mount.
2.
Remove locknut (10), washer (9), and lower rear engine pad (8) from frame (7). Discard
locknut (10).
3.
Position hydraulic jack (13) and wood blocks (14) under transmission (12) lifting point. Raise
transmission (12) just enough to take weight off upper rear engine pad (11).
WARNING
Do not put fingers between frame and engine support. Jack
failure may cause injury to personnel.
4.
Remove screw (4), washer (5), and upper rear engine pad (11) from frame (7) and engine
support (6).
INSTALLATION
1.
Install upper rear engine pad (11) on frame (7) with washer (5) and screw (4).
2.
Lower hydraulic jack (13) and remove jack (13) and wood blocks (14) from transmission (12).
3.
Install lower rear engine pad (8) on frame (7) with washer (9) and new locknut (10). Tighten
locknut (10) 6570 lb-ft (8895 Nm).
NOTE
Perform step 4 for engine left rear mount.
4.
Install accelerator linkage (3) on throttle control lever (2) with nut (1).
5.
Lower and secure hood (TM 9-2320-361-10).
6.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
7.
Connect battery ground cable (WP 0126 00).
0025 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version