Table 2. STE/ICE-R No-Go Chain Test - continued

TM 9-2320-361-24-1

0018 00

SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--

REPROGRAMMABLE STE/ICE-R NO-GO CHAIN TROUBLESHOOTING (Contd)

Table 2. STE/ICE-R No-Go Chain Test (Contd).

NOTE

Test GO 1 (WP 0017 00), VTM Connections and Checkout,

must be performed before running any other STE/ICE-R test.

GOVERNOR/POWER TEST FAULT ISOLATION

NG90

MODE

NOTE

If vehicle has failed power test, start with step 1. If

vehicle has failed governor checks, start with step 2

on next page.

CAUTION

Check that air inlet is clear of tools, debris, dirt, and dust before performing

following test. Failure to do so may cause damage to engine when vehicle is started.

REMOVE AIR CLEANERREPEAT POWER TEST:

Remove air cleaner (WP 0052 00) from air intake housing.

Repeat power test--GO 7, step 2.

Does engine pass power test with air cleaner out?

YES

Install new air cleaner element (WP 0052 00).

NOTE

Reinstall air cleaner.

After completing repair, rerun GO Chain tests (WP 0017 00)

to verify that problem is fixed and no other problems exist.

CAUTION

Do not perform more than 2 compression unbalance

tests in a row to prevent discharge of vehicle batteries.

Engine must be at normal operating temperature before

performing compression unbalance test to ensure

accurate compression unbalance results.

NOTE

The compression unbalance test takes

approximately 15 seconds to run.

Proceed to next page.

0018 00-28