Table 2. STE/ICE-R No-Go Chain Test - continued

TM 9-2320-361-24-1

0018 00

SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--

REPROGRAMMABLE STE/ICE-R NO-GO CHAIN TROUBLESHOOTING (Contd)

Table 2. STE/ICE-R No-Go Chain Test (Contd).

BATTERY TESTS (Contd)

NG81

MODE

MEASURE BATTERY RESISTANCE CHANGE

Dial 79 into TEST SELECT switches.

Does GO appear in display?

PROMPTING

MESSAGE

YES

Error message is displayed.

Press starter switch until

OFF appears on display.

Refer to the error messages in WP 0016 00.

Correct as necessary and repeat test.

Wait for display to change.

PROMPTING

MESSAGE

Is a number displayed?

YES

If display shows GO, there is a bad connection in starter

Proceed to next page.

circuit. Check cables and connections to starter and

retest. If display still shows GO, then you may have a

defective battery in the series pair being tested. Test

other battery in the pair.

If display shows. 9.9.9.9, there may be a bad connection

on battery being tested. Clean and tighten connections

on battery and retest.

If display shows E013, four dashes, or .9.9.9.9, the

battery being tested may be in a discharged state.

Check battery electrolyte level, charge battery and then

retest.

If display shows E013, four dashes, or .9.9.9.9 after

battery has been charged, replace battery (WP 0127 00).

NOTE

After completing repair, rerun GO Chain tests (WP 0017 00)

to verify that problem is fixed and no other problems exist.

0018 00-26