 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R Go Chain Test - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0017 00
SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--REPROGRAMMABLE
(STE/ICE-R) GO CHAIN TROUBLESHOOTING (Contd)
Table 2. STE/ICE-R Go Chain Test (Contd).
GOVERNOR CHECK/POWER TEST (Contd)
G07
TK
MODE
CAUTION
Do not perform power test if engine temperature
is above normal operating temperature.
However, the engine should be at operating
temperature before performing the power test.
NOTE
TEST NO.
TEST
The VID of Test GO1 must have been entered prior to the
power test. This will prevent an error message (E014) and
12
POWER TEST
unsuccessful completion of the power test. If you do not
(RPM/SEC)
have a VID number, but the number of cylinders were
POWER TEST
13
entered in GO1, use Test 12 for power test instead of Test
(% POWER)
13. When using Test 12, the first number to appear on the
display is the signal to release the accelerator.
2
PERFORM POWER TEST:
Dial 13 into TEST SELECT switches and press TEST.
Wait for prompting message CIP to appear.
PROMPTING
When CIP appears, rapidly press down on accelerator and hold
MESSAGE
it to the floor until VTM displays OFF.
When OFF appears, release accelerator.
A number representing percentage power will appear on VTM.
Is the percentage of power at least the minimum?
See chart below.
% POWER--MINIMUM LIMIT FOR TEST
ALTITUDE
YES
NO
Does vehicle have a
VEHICLE
0 TO
2000 TO
ABOVE
fuel/water separator?
2000 FEET
4000 FEET
4000 FEET
M35A2 (TURBO)
60%
50%
45%
LDT-465-1C
NO
YES
ALL OTHER
Proceed to next desired test.
75%
66%
60%
VEHICLES
GO8
Service fuel/water separator (WP 0063 00).
Repeat power test.
Proceed to Governor/Power
If power test still fails, proceed to
NG90
Test Fault Isolation, NG 90
Governor/Power Test Fault Isolation, NG 90
0017 00-19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version