|
|
TM 9-2320-361-24-1
0012 00
BATTERY AND CHARGING SYSTEM TROUBLESHOOTING (Contd)
Table 2. Starting System Troubleshooting Procedure (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test 3. Test for battery voltage into
1. STARTER
power accessory switch pins A
WILL NOT CRANK
and C.
(Contd)
1. Remove two leads 11 from
1. If voltage is not present, go to
power accessory switch pins A
test 5.
and C. Using multimeter,
2. If voltage is present, install both
check for battery voltage on
leads 11 into pins A and C and go
contact ends of leads 11.
to test step 2.
2. Observe voltmeter in dash for
1. If voltmeter works, go to test
proper operation.
step 5.
2. If voltmeter does not work, go to
test step 3.
3. Remove leads 27 from pin B of 1. If voltage is present, go to test
power accessory switch. With
step 5.
power accessory switch turned 2. If voltage is not present, go to
on, check for battery voltage
step 4.
at pin B.
0012 00-10
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |