|
|
TM 9-2320-361-24-1
0012 00
BATTERY AND CHARGING SYSTEM TROUBLESHOOTING (Contd)
Table 1. Battery System Troubleshooting Procedure (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test 2. Disconnect battery ground
ALL VEHICLE
cable (WP 0126 00) and test
ELECTRICAL SYSTEMS
battery cables as follows:
INOPERATIVE (Contd)
1. Set multimeter to RX 1 scale.
2. Check for continuity of
1. If resistance is greater than 1 ohm,
battery cables no. 6 and 68
repair or replace battery cables
and for worn or frayed
insulation.
2. If insulation is worn or frayed,
repair or replace battery cables
3. Check continuity of battery
1. If resistance measure greater than
cable no. 7 to frame ground.
1 ohm, clean cable no. 7 connection
at right-hand frame rail.
2. If continuity is still greater than
1 ohm, repair or replace battery
cable (WP 0126 00 and
4. Connect battery ground cable
test 3.
Test 3. Check for battery voltage at
starter solenoid.
1. Set multimeter to a voltage
range that will measure
24 VDC.
2. Check lead no. 6 at contact 2
If battery voltage is not present, clean
of starter solenoid for battery
connections of lead no. 6 at contact
voltage.
no. 2 of starter solenoid (WP 0088 00).
0012 00-4
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |