 |
|||
|
|
|||
|
Page Title:
POWER PLANT HEATER REMOVAL, REPAIR, AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME
3
NOTE
Do only those steps needed to put back new parts taken
off in frame 2. Parts not called out are for reference
only.
Put electrical connector (1) with electrical leads in place on bracket (2).
1.
Screw in and tighten four screws (3).
Put terminal strip (4) in place on bracket ( 2). Screw in and tighten four
2.
screws (5).
Put diode holder (6) in place on bracket (2). Screw in and tighten two
3.
screws (7).
Put motor resistor (8) in place on bracket (2). Put in screw (9). Screw on
4.
and tighten nut (10).
END OF TASK
21-47
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version