 |
|||
|
|
|||
|
Page Title:
POWER PLANT HEATER REMOVAL, REPAIR, AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 7
NOTE
Put gasket (1), orifice plate (2), and gasket (3) on cover
plate (4) exactly as shown. Put orifice plate and gasket
assembly (5) on fuel control valve (6) exactly as shown.
Put new gasket (1), orifice plate (2), and new gasket (3) on cover plate (4).
1.
Put orifice plate and gasket assembly (5) on fuel control valve body (6).
2.
Put thermostat (7) and clamp (8) on orifice plate and gasket assembly (5).
3.
Screw in three screws (9) finger tight.
4.
Tighten three screws evenly,
tightening each one a little at a time.
5.
Slide two electrical leads (10) on terminals of thermostat (7).
Do frame 2 again if fuel control valve did not pass fuel flow test. If fuel
6.
control valve still does not pass fuel flow test, get new fuel control valve.
END OF TASK
21-44
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version