 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 18
1.
Move shifter rod (1) until detent (2) in shifter fork (3) goes into earth auger
position (4) in shifter shaft (5). Sliding gear (6) should be meshed with
splined portion of rear output shaft (7) only. Sliding gear (6) should not be
touching inside of housing (8) or meshing with forward and reverse speed
gears (9) or reverse idler gear (10).
If sliding gear (6) is touching inside wall of housing (8) or meshing with any
2.
gear, move shifter shaft (5) with screwdriver.
Check that sliding gear (6) does not mesh with any gears in neutral position.
3.
If gear does mesh, go back to frame 15.
4.
Check that sliding gear (6) meshes fully with reverse idler gear in rear
winch reverse position. If gear does not mesh, go back to frame 16.
5.
Check that sliding gear (6) meshes fully with forward speed gear in rear
winch forward position. If gear does not mesh fully, go back to frame 17.
GO TO FRAME 19
18-267
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version