 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME
2
Place wooden block, 4 inches x 4 inches x 4 feet, under upper end
1.
of two hoist cylinder assemblies (1).
2.
Take out two screws with lockwashers (2). Hold lower retainer (3)
so that it will not fall when last screw (2) is taken out. Take out
upper retainer (4).
3. Take out two screws and lockwashers (5).
Take off two bearing caps (6).
4.
CAUTION
Bypass tubes on outside of hoist cylinder assembly (1)
are easily damaged. Be careful when lifting out hoist
cylinder assembly.
Soldier A
5.
Hold hoist cylinder assembly (1).
Soldier B
Using pry bar, pry bottom of hoist cylinder assembly (1) towards
6.
rear of truck.
Pull piston rod (7) out of crosshead (8) and lift hoist cylinder
Soldiers
7.
A and B
assembly (1) off truck.
END OF TASK
18-192
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version