 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 33
1.
Place seal (1) in groove of bearing retainer (2).
2.
If retaining rings (3) were taken out of idler pulley (4), put on retaining
rings.
If bearing cups (5) were taken out, press new cups into idler pulley (4).
3.
4.
Pack tapered roller bearings (6) with type GAA, MIL-G-10924 automotive
grease.
Put bearings (6) into bearing cups (5).
5.
Place idler pulley (4) on pulley shaft (7).
6.
Place seal (1) in groove of bearing retainer (8).
7.
8.
Place bearing retainer and nut (8) on pulley shaft (7). Tighten nut so
pulley turns without end play in bearing.
Put on cotter pin (9).
9.
NOTE
Idler pulley and bracket assembly will be installed
during follow-on tasks.
END OF TASK
18-145
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version