|
|
TM 9-2320-209-34-2-2
FRAME
3
Put on spacer (1) and key (2). Put in gear (3).
1.
NOTE
Put in pry bar through hole in housing (4) and press
worm drive gear (5) to keep leveler drive shaft from
turning. This helps in tightening nut (6) at end of
shaft.
2.
Put in flat washer (7), nut (6), and cotter pin (8).
Put grease into housing (4).
3.
GO TO FRAME 4
17-683
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |