|
|
TM 9-2320-209-34-2-2
1.
Put thin coat of gasket cement to part of head (1) next to casing (2).
Place casing on bench, outboard head (3) down.
2.
Push inboard head (1) down rotor (4). Turn inboard head to seat pin hole
of liner (5).
Put in eight lockwashers (6) and screws (7).
3.
NOTE
If rotor (4) binds, loosen screws (7) and tap
inboard head (1) with hammer. Tighten screws.
Put in key (8) in end of rotor (4).
4.
GO
TO FRAME 6
17-246
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |