Data plates held with drive screws - TM-9-2320-209-20-3-40191

TM 9-2320-209-20-3-4

(3) Data plates held with drive screws.

FRAME 1

Using hammer and chisel, cut off head of each drive screw (1) holding data

plate (2) in place.

Using hammer and center punch, center punch each drive screw (1).

CAUTION

Before punching drive screw ends through an item, make

sure drive screws (1) go through to other side. Do not

punch screws held in deep solid block or hollow bottomless

assemblies. Damage to equipment could result.

Using 1/8-inch punch and hammer, drive out rest of drive screws (1) and take

off data plate (2).

END OF TASK

21-27