 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM
9-2320-209-20-3-3
FRAME 3
1.
Working under truck, lay back end of intermediate shaft (1) on frame
crossmember (2).
2.
Put spacer (3) on front pillow block (4). Put pillow block in place on frame
crossmember (5), alining screw holes.
Put two screws (6) through holes in frame crossmember (5).
3.
4.
Using 3/4-inch wrenches, screw on and tighten two nuts (7).
Do steps 2 through 4 again for other end of intermediate shaft (1).
5.
Move intermediate shaft (1) so same amount of shaft goes through each
6.
pillow block (4).
7.
Using 1/8-inch allen wrench, tighten two setscrews (8).
GO
TO FRAME 4
18-162
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version