 |
|||
|
|
|||
|
Page Title:
REAR SPRING SEAT REMOVAL AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-2
FRAME 4
1.
Pack cover (1) with grease. Grease both sides of gasket (2). Put gasket on
cover, lining up screw holes.
2.
Put cover (1) with gasket (2) onto spring seat (3), lining up screw holes.
Put lockwashers (4) onto screws (5) and, using 1/2-inch wrench, screw in
and tighten six screws.
Using torque wrench, tighten screws (5) to 16 to 20 pound-feet.
3.
4.
Using rag, clean away any grease that squeezed out.
5.
Jack spring (6) down until it just touches spring seat (3).
GO TO FRAME 5
17-44
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version