 |
|||
|
|
|||
|
Page Title:
UNIVERSAL JOINT (SNAPRING, C-RING, AND BEARING CAP TYPE) REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME 5
1.
Place yoke (1) on wood block as shown.
NOTE
Diameter of drift pin punch should be just a little smaller
than diameter of journal.
2.
Center drift pin punch (2) on face of journal (3) as shown. Tap drift pin
punch lightly with hammer until bottom bearing (4) is driven out.
Tilt spider (5) to one side and lift spider out of yoke (1).
3.
Take four gaskets (6) and four retainers (7) off four journals in spider (5).
4.
Throw away gaskets and retainers.
END OF TASK
10-19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version