 |
|||
|
|
|||
|
Page Title:
ENGINE STARTER REMOVAL AND REPLACEMENT (TRUCKS WITH PUSH- BUTTON STARTER SWITCH) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME 3
CAUTION
Starter weighs 50 pounds. Be careful not to let it
fall when lifting starter into engine compartment.
NOTE
If starter will not seal firmly against adapter, do not
force it. It may be due to gear position. Take starter
out, turn starter drive gear slightly, and try again.
Put starter (1) in engine compartment. Aline three holes in starter mounting
1.
flange (2) with mounting studs (3). Solenoid (4) must be at top as shown.
2.
Push starter straight in on mounting studs (3) until it is firmly seated. Put
three lockwashers (5) on three mounting studs (3).
Screw on and hand tighten three nuts (6) onto three mounting studs (3).
3.
4.
Using 15/16-inch socket wrench, evenly tighten three nuts (6).
IF PUTTING BACK STARTER, pn 10911018-1, GO TO FRAME 4.
IF PUTTING BACK STARTER, pn 10935376-1, GO TO FRAME 5
7-61
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version