|
|
![]() TM 9-2320-209-20-3-1
FRAME 7
Put hold down clamp (1) on block (2) and aline holes.
1.
2.
Put in two screws and lockwashers (3). Using flat-tip screwdriver, tighten
screws.
3.
Seal terminal cover (4) and base (5) with silicone compound.
4.
Put terminal cover (4) on base (5).
5.
Using screwdriver, tighten screws.
Put on two screws and lockwashers (6).
6.
Join plug (7) to connector (8).
NOTE
Follow-on Maintenance Action Required:
1. Reconnect battery ground cable. Refer to para 7-58.
2. Adjust fan belt tension. Refer to para 6-9.
3. Start engine and check that battery-generator indi-
cator is in green area. Stop engine. Refer to
TM 9-2320-209-10.
4. Close hood and side panels. Refer to TM 9-2320-
209-10.
END OF TASK
7-26
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |