 |
|||
|
|
|||
|
Page Title:
ALTERNATOR AND PULLEY REMOVAL AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME
6
Using mechanical puller (1), set adjustable puller arms (2) over rear edge of
1.
alternator pulley (3) as shown.
2.
Screw puller bolt (4) in until it presses against alternator shaft (5) as shown.
Using 3/4-inch wrench, slowly tighten puller bolt (4) until alternator pulley
3.
(3) is loose on shaft (5). Pulley will move in direction shown.
Take puller (1) off alternator pulley (3) and slide pulley off end of shaft (5).
4.
Tape key (6) to shaft (5) so it will not be lost.
5.
END OF TASK
7-19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version