 |
|||
|
|
|||
|
Page Title:
EXHAUST SYSTEM (HORIZONTAL) REMOVAL AND REPLACEMENT (TRUCKS M50A1, M50A2, AND M50A3) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
Put cable clamp (1) with cable (2) on bypass valve (3).
1.
2.
Aline holes and put in capscrew (4) and screw on locknut (5).
3.
Put end of cable (2) 1/2 inch through hole in lever (6) and using screwdriver,
tighten screw (7). Using pliers, bend cable end at 45 angle.
4.
While holding lever (6) towards back of truck, slide cable case (2) in clamp (1)
until there is no slack between clamp and lever.
5.
Using 7/16-inch wrenches, tighten locknut (5) and cap screw (4).
GO TO FRAME 7
TA
080717
5-35
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version