 |
|||
|
|
|||
|
Page Title:
CLUTCH CONTROL AND LINKAGE REMOVAL , REPAIR, REPLACEMENT, AND ADJUSTMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-20-3-1
FRAME 2
1.
Screw nut (1) onto rod (2) and then screw clevis (3) onto rod.
2.
Screw clevis (3) in or out on rod (2) as necessary to set length. Set length
between clevis ( 3 and 4) hole centers to 14 1/8 inches as shown.
Using 3/4-inch wrenches, hold clevis (3) and tighten nut (1) .
3.
Put clutch throwout shaft lever (5) on clutch throwout shaft (6). Center line
4.
must be one spline to rear of shaft center line as shown.
GO TO FRAME 3
TA
047259
3-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version