REPLACING ENTIRE CABLE ASSEMBLY (OTHER THAN THE WINCH CORNER CABLE ASSEMBLY) - continued

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0038 00

UNIT MAINTENANCE

Lay the cables (1) in the channels (2) on the inside of the CBC, keeping the threaded ends (3) accessible.

Install the threaded end (3) of each terminal (rod end), one on the long cable and one on the short cable

going down each corner (other than the winch corner) into the tunbuckle body (4) removed earlier. Screw

the terminal ends (3) into the turnbuckle body (4) an equal amount until approximately 1/8 inch of thread

are still exposed. Repeat for each of the three turnbuckle bodies.

When screwing the terminal ends (3) into the turnbuckle body (4), be sure that the line (5) on the shaft of

the terminal end (3) is lined up EXACTLY with the small angled cutout (6) located on the edge of the

turnbuckle body (4). If the line (5) is not lined up exactly with the cutout (6), the locking pins (7) installed in

a later step will not install in the turnbuckle body.

0038 00-16