REPLACING WINCH CORNER CABLE ASSEMBLY

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0038 00

UNIT MAINTENANCE

REPLACING WINCH CORNER CABLE ASSEMBLY

The following procedure applies only to the replacement of the short cable assembly located at the winch

corner. To replace any of the other cable assemblies, refer to the section of this work package entitled

"REPLACING CABLE ASSEMBLIES OTHER THAN THE WINCH CORNER".

Once the cables are unwound and completely disconnected from the winch barrel, remove the corner

pulley cover plate (1) by removing the two screws (2,6) that secure it in place. Note that the screw (2)

closest to the winch has a spacer (3) and is secured with a locknut (4).

Lift and remove the right hand pulley (5) and set it aside.

0038 00-5