Click here to make tpub.com your Home Page

Page Title: SIDE WALL REPAIR OF DEPRESSION OR SMALL PUNCTURE - continued
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 10-5411-233-13&P
CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0018 00
UNIT MAINTENANCE
WARNING
Methylethylketone is flammable and toxic and shall be used only in a
well-ventilated area away from all sparks or open flame. Gloves and
safety goggles should be worn during use.
Wipe sanded surface with clean cloth dampened in solvent and immediately wipe solvent from surface
with a clean, dry cloth.
Mask sanded surface with masking tape (1).
Mix a small quantity of adhesive (2) in accordance with manufacturer's instructions.
Using spatula or putty knife (3), fill damaged area with adhesive.
Cure adhesive at room temperature (75 degrees F) for 72 hours. Alternate cures can be achieved by
exposing the repaired area to 150 degrees F for 3 to 4 hours, or 200 degrees F for 40 to 60 minutes. If
150 degree F or 200 degree F cures are used, allow additional time for repaired area to warm to curing
temperature and ensure that the surface temperatures of the CBC do not exceed 225 degrees F.
Sand surface of cured adhesive to conform to surrounding area.
Remove masking tape (1) and clean repaired surface.
Apply alodine solution. Apply the alodine solution with a brush, paint spray gun, cellulose sponge, etc.,
to the cleaned and rinsed aluminum surface, liberally, quickly and evenly. Allow it to act from 1 to 5
minutes before rinsing.
NOTE
The solution should be applied to only as much surface as can be coated and rinsed before the
alodine solution dries.
Proceed with the coating and rinsing until the entire surface is coated with alodine.
Rinse. Before the alodine solution dries, wipe it from the surface with a clean cloth or sponge wet with
clean water. The alodine solution may also be rinsed from the surface with clean water from a hose.
Dry. After the rinsing has been finished, allow the work to air dry. Drying can be speeded by wiping with
clean, dry rags. Clean, dry, compressed air should be used to blow moisture from joints, depressions,
etc., and to speed the drying. When the surface is entirely dry, the part is ready for service without further
treatment, or if desired, it may be painted in accordance with manufacturer's directions.
Refinish in accordance with WP 0039.
0018 00-4

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business