|
|
TM 10-5411-233-13&P
CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0015 00
UNIT MAINTENANCE
FINAL INSTALLATION OF CLAMP PLATE ASSEMBLY
Two clamp plate assemblies (1) (one on each side) are installed at the corners of the rear mounting plate
assembly (2) and are used to secure the CBC/mounting plate combination (3) to the trailer bed (4).
With the CBC is in its final position, position the spacer (5) and bottom plate with rubber pad (6) under the
installed portion of the clamp plate assembly (7) located at the rear passenger side (8).
Install a hex head bolt (9) through each hole in the clamp plate channel (10), spacer (5), and bottom plate
with rubber pad (6). Make sure that the rubber pad on the bottom plate (6) faces up and engages
securely on the underside of the trailer bed (4).
Secure the assembly with 1/2 inch flat washer (11), and 1/2-13 UNC locknut (12) Tighten the clamp plate
assembly hardware securely.
Repeat the above procedure for the clamp plate assembly located on the rear driver side of the
CBC.Tighten the clamp plate assembly hardware securely.
Once the CBC has been securely installed to the vehicle, the Cargo Bed Cover is ready to be used as
detailed in WP 0005 entitled "OPERATION UNDER USUAL CONDITIONS".
MODIFYING THE LMTV TRAILER LADDER
The ladder that is supplied with the LMTV Trailer must be modified to permit clearance of the CBC
personnel door and the ladder. To modify the ladder, 5 inches of the top left leg must be cut off. Once the
top of the left leg has been shortened, the cut end should be protected with a plastic cap.
0015 00-17
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |