Click here to make tpub.com your Home Page

Page Title: APPLYING RTV SILICONE SEALANT, FINAL ASSEMBLY OF GUSSET PLATES
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 10-5411-233-13&P
CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0015 00
UNIT MAINTENANCE
APPLYING RTV SILICONE SEALANT, FINAL ASSEMBLY OF GUSSET PLATES
NOTE
Sealant should be applied only if the CBC is to be immediately mounted
to the vehicle bed. The sealant has a working time of approximately 20
minutes and will start to cure after that time. Installing the CBC on the
vehicle after the sealant begins to cure may adversely affect the
sealant's ability to properly bond with the vehicle bed.
Once all gaps have been identified and eliminated as described above, a bead of RTV (silicone) sealant
must be applied where the weather stripping contacts the vehicle bed and around the threshold area.
To apply the RTV sealant, raise the CBC to a comfortable working height using the hoisting sling.
Install the supplied cartridge of sealant into a standard caulking gun. Trim the tip of the cartridge so that a
bead approximately 3/16 to 1/4 inch in width can be applied.
Apply a continuous bead of sealant (1) 3/16 to 1/4 inch in width on the surface of the weather stripping (2)
along the outer edge. Start at one point at the underside of the CBC and move around the entire
perimeter of the CBC applying sealant to all weather stripping surfaces.
Once sealant has been properly applied to all weather stripping surfaces, the CBC should be lowered into
position on the vehicle bed. Take care to return the CBC in the same position so that the hole in the
gusset plates align with the slotted hole in the vertical trailer support and that the flat portion of the gusset
plate contacts the vertical trailer support.
Install one 7 inch bolt (3) and flat washer (8) through both slotted holes (6) in the vertical trailer support
(7). Install a flat washer (8) and locknut (9) on the end of the 7 inch bolt (3). Tighten the hardware on each
gusset plate securely.
7
9
8
6
6
8
2
3
4
1
5
0015 00-15

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business