UNIT MAINTENANCE - continued - TM-10-5411-233-13-P0109

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0013 00

UNIT MAINTENANCE

Marking the location of the carrier mounting angle holes. The bottom edge of the lower section of the

Cargo Bed Cover is attached to the vehicle bed by means of a series of carrier mounting angles (1).

These angles and threshold have a total of 27 predrilled mounting holes where only 19 of the holes (2)

are used.

To transfer the position of the carrier mounting holes to the vehicle bed, use the 3/8 inch transfer punch

(3) supplied with the mounting kit and mark the vehicle bed in 19 places. There are 4 holes each in the

carrier mounting angles at the front (4), left (5), and right sides (6) of the CBC. There are two holes in

each of the two smaller carrier mounting angles (7) at the rear of the CBC located on either side of the

door opening and a total of 3 holes in the threshold.

Once all 19 hole positions have been marked, the CBC can be removed from the vehicle bed and

returned to its shipping pallet while the holes are drilled in the vehicle bed and Rivnuts installed.

Front of

4 Vehicle cab

3.0 inches

inside bed

+/- .13

Center line

of CBC and

Vehicle

Bed

NOTE: Only those carrier

M35A2

Cargo Bed

mounting angle holes

Truck Bed

Cover Lower

indicated on this drawing

Section

by a short arrow on the

inside of the CBC require

drilling. The additional 8

holes shown on the side

carrier mounting angles

DO NOT require drilling

and Rivnut installation.

0013 00-5