Stowing the Lifting/Locking Assemblies - continued

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0005 00

OPERATION UNDER USUAL CONDITIONS

Once the handle (1) is in its locked position, remove the hairpin cotter (2) on the clevis pin (3) installed on

the roof stowage block (4) and slide the clevis pin (3) out of the stowage block (4). Keep the hairpin cotter

(2) and clevis pin (3) close by.

While swinging the lifting/locking assembly (5) up to its stowage block (4) on the underside of the roof,

rotate the entire lifting/locking assembly (5) clockwise. Stow the lifting/locking assembly so that the

bracket (6) straddles the stowage block (4). Make sure that the holes (7) in the bracket (6) are aligned

with the holes in the stowage block (4) and protruding pins (8) in the lifting/locking assembly base go into

the recess openings in the cargo bed cover roof.

Install the clevis pin (3) removed earlier through one side of the bracket (6), through the stowage block

(4), and out the opposite side of the bracket (6).

Install the hairpin cotter (2) removed earlier in the end of the clevis pin (3).

Repeat this procedure for each of the three remaining lifting/locking assemblies until all are in their

stowed positions on the underside of the roof.

0005 00-30