RETRACTING THE CARGO BED COVER - continued

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0005 00

OPERATION UNDER USUAL CONDITIONS

Once the door latch rod has been removed and stowed on the back of the upper door panel, loosen and

remove the three hand knobs with threaded studs (7) that secure the lower door panel (1) to the upper

door panel (6). Be sure to support the door with a free hand.

While positioned outside the door, lift the lower door panel hinge pin (8) up and out of the hinge pivot hole

(9) located in the threshold at the lower left corner of the personnel door opening.

The door hinge (10) on the outside surface (11) of the door is removed and stowed on the inside surface

(12) of the door when the lower door panel (1) is stowed on the underside of the roof.

Set the lower door panel (1) on a work surface and remove the screws and washers (13) that secure the

hinge (10) to the outside surface (11) of the lower door panel (1). Remove the hinge (10) and spacers

(14). Note that there are a total of three spacers between the hinge and the door surface. Two spacers

are placed beneath the hole closest to the hinge pivot pin and one spacer is placed beneath the

remaining hole. The spacers must always be installed in these positions relative to the hinge pivot pin.

Turn the lower door panel (1) over so that the outside surface (11) is face down. Place the spacers (14)

between the hinge and the door surface as detailed above with two spacers closest to the hinge pivot pin.

Position the hinge (10) in its stowage location (15) on the inside surface (12) of the door.

Secure the hinge (10) in place using the screws and washers (13) removed in the previous step.

0005 00-26