ASSEMBLING THE PERSONNEL DOOR - TM-10-5411-233-13-P0054

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0005 00

OPERATION UNDER USUAL CONDITIONS

Install the lower door latch rod (1) in its operational position by sliding it down through the two door latch

rod guides (8) located on the lower door panel (9).

Engage the upper hole (10) on the door latch rod (1) onto the pin (11) of the door latch (6) from which it

was removed in an earlier step. Install the hairpin cotter (4) to secure the door latch rod (1).

Test the action of the door latch (6) by opening and closing the assembled personnel door. Ensure that

the door closes properly, that the door latch rods at the upper and lower edges of the door engage

properly in their contact points, and that the center case latch engages the strike plate properly.

Make sure that the door operates freely and that the weather seal surrounding the door is positioned

properly to block all openings. If the personnel door does not operate smoothly, check to make sure that

the lower panel of the personnel door has been installed correctly and that the tabs and cutouts on the

inside surface of the personnel door are aligned correctly. Ensure that the three hand knobs with

threaded studs are securely tightened.

Once the personnel door has been properly installed, the fully extended Cargo Bed Cover is ready for

use.

0005 00-12