OPERATION UNDER USUAL CONDITIONS - TM-10-5411-233-13-P0048

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0005 00

OPERATION UNDER USUAL CONDITIONS

The base (3) at the bottom of the lifting/locking assembly (1) is positioned over the corner fitting pulley

assembly (2) on the lower section. Pins (4) protruding from the base (3) of the lifting/locking assembly (1)

are aligned with slots (5) located in the interlock extrusion at the corner fitting pulley assembly (2).

In order to move the lifting/locking assembly (1) into its final position and properly engage the pins (4) on

the base (3) in the slots (5), it may be necessary to move the handle (6) up and down in a wiggling motion

to get the assembly into the desired position.

Once the lifting/locking assembly (1) is in position, remove the hairpin cotter (7) that secures the handle

clip (8).

Swing the handle (6) up and lock it into position by positioning the hole (9) in the handle clip (8) over the

portion of the clevis pin protruding from the main body tube of the lifting/locking assembly (1). Once in

position, replace the hairpin cotter (7) removed earlier.

Repeat the above sequence moving clockwise inside the CBC for each of the remaining three

lifting/locking assemblies in each corner of the Cargo Bed Cover.

Once all four lifting/locking assemblies are locked in position, the Cargo Bed Cover will be in its fully

extended and locked position.

0005 00-6