TECHNICAL PUBLICATIONS AFFECTED/CHANGED.

MWO 9-2300-200-20-1

c. Work Force and Man-Hour Requirements:

WORK FORCE/SKILLS

MAN-HOURS

1 each vehicle operator to remove register cover,

0.50 hrs

spray foam-in insulation in inside bottom van

body cavity and seal vents extending to foldout

walls and floors.

0.10 hrs

Operator will apply cement sealant to cover

plate and install cover plate to openings in front wall.

0.15 hrs

Operator to dispose of register covers as hazardous waste

0.05 hrs

Disconnect fuel lines and electrical connections

from heater.

0.10 hrs

Quality control inspection.

0.10 hrs

Where heaters have already been removed, remove

residual bracketery/plates and clean areas to allow

adequate cement adherence.

Total man-hours required to seal vents in one vehicle is 1.0 hour.

d. MWO's to be applied to or concurrently with this MWO. Not applicable.

e. Additional Information. Apply MWO in well-ventilated area. MWO should not be applied by personnel

with respiratory problems. Siliprene contains Toluene. Great Stuff contains less than 15%4.4 Diphenylmethane

Dxisocyanate (MDI). Chemicals are safe after expansion. Use disposable gloves when applying MWO to pre-

vent skin contact with asbestos fibers.

7. TECHNICAL PUBLICATIONS AFFECTED/CHANGED.

TM 9-2320-211-20P &34P - - (M291A1 , M291A2D, M291A2C)

TM 9-2330-238-14&P - - (M313, M447)

TM 9-2320-260-34P - - (M447, M447C, M749, M750)

TM 9-2320-209-34P - - (M292A1, M292A2, M292A5)

8. MWO KITS/PARTS AND THEIR DISPOSITION.

a. Kits/Parts needed to apply this MWO. Parts used to make up this MWO kit include the following:

Kit - NSN 2540-01-328-3328 - (CAGE 19207, PN 57K0880)

Yellow Spray Paint - NSN 8010-00-079-3764

Stencil - refer to paragraph 14 b(2).

b. Contents of MWO Kit. The following is a list of parts that are included in the MWO kit. The kit should be

inventoried before work begins.