OIL CAN POINTS

OIL CAN POINTS

DO NOT LUBRICATE

Every 1,000 miles (1,600 km) or monthly,

S p r i n g s , leaves, c l u t c h release bearing,

g e n e r a t o r , alternator, starter, and shock

lubricate: door, tailgate, windshield and side

absorbers.

panel hinges, locks and latches, transfer case

and power takeoff shift linkage, clutch and

LUBRICATE AT TIME OF ASSEMBLY BY

brake pedal linkage, handbrake shoe outer

DIRECT SUPPORT (DS) AND GENERAL

pin, handbrake control, winch propeller shaft

s h e a r pin, rear winch and power-divider

SUPPORT (GS) PERSONNEL

control lever linkages, earth boring machine

Clutch pilot bearing, clutch release bearing

operating handle linkage, outrigger control

carrier, speedometer flexible shaft, revolving

lever linkage, discharge valve control lever

platform bearings, and lineguide roller shaft

pivot pin, and tailgate control lever linkage

bearings.

with seasonal grade OE. Coat roller sheave

spindle bars with thin layer of GAA. For

GENERAL NOTES

vehicles in storage, o i l a n d o p e r a t e t h e

handbrake lever at 30-day intervals to allow

G e n e r a l notes are located on pages 30

f o r penetration of lubricant between the

through 33.

handbrake lever shaft and housing.

NOTE

All Iubrication capacities are approximate (approx).

Military symbols for lubricants are found in general notes number 21.

Hours in the interval column refer to hours of operation. When two intervals are shown, lubricate at the interval

which occurs first.

LO 9-2320-209-12-1

PAGE 2 OF 34