Click here to make tpub.com your Home Page

Page Title: Figure 5-14. Bus Bar Maintenance
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-6115-663-13&P
CAUTION
The control panel connector P3 is connected to connector J4. Movement of the switch box
cover is limited. To prevent damage to control panel wiring harness, use caution
removing switch box cover. Failure to observe this caution can result in equipment
damage. .
2. Carefully position switch box cover (4) in front of switch box.
3. Disconnect P3 (7) from J4 (8) and set switch box cover (4) out of the way.
4. Remove switch box cover (4).
NOTE
The bus bar is physically connected to L0 of the switch box assembly and is a common
ground. Leads connected to bus bar may be connected to any terminal on the bus bar.
5. Remove cap screws (4, figure 5-14), lock washers (10), flat washers (9), and electrical leads (5) from
bus bar (1).
6. Remove nut (3) and lock washer (2).
7. Remove nut (6), lock washer (7), flat washer (8), and bus bar (1).
Figure 5-14. Bus Bar Maintenance

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business