1 TON TRAILER GENERATOR MOUNTING RAIL MAINTENANCE.

TM 9-6115-661-13&P

REPAIR

Refer to appendix G and replace fuel drain assembly.

INSTALLATION

1. Position tube nipple (7) on the equipment.

2. Install the flat washer (5), retaining nut (6) and drain cock valve (4) then tighten.

3. Install drain cock valve (4) on tube nipple (7).

4. Install hose assembly (1) and tighten hose fittings (8).

5. Install hose fitting (3) and tube cap (2) on drain cock valve (4).

6. Close drain cock valve (4) and open valve (9).

5-14 1 TON TRAILER GENERATOR MOUNTING RAIL MAINTENANCE.

b. Installation

This task covers: a. Removal

INITIAL SETUP

Equipment Conditions

Tools

Reference

General Mechanic's Tool Kit

Trailer handbrakes set, front support

leg/landing leg lowered, and rear leveling-

Materials/Parts

support jack lowered; paragraph 2-3.2.1.

Nuts, Self-Locking

Generator set removed, paragraph 5-6.

Accessory box removed, paragraph 4-19.

Front platform removed, paragraph 4-25.

REMOVAL

1. Remove ten self-locking nuts (5, Figure 5-17), twenty flat washers (3 and 4), and ten cap screws (2)

from each generator mounting rail (1).

2. Lift generator mounting rails (1) off trailer frame (6). Save generator mounting rails (1).

3. Remove two locknuts (7), four flat washers (8), two bolts (9), and bracket (10).