ACCESSORY BOX MAINTENANCE. - TM-9-6115-661-13-P0134

TM 9-6115-661-13&P

2. Remove five self-locking nuts (5), flat washers (3), and bolts (2), that secure rear step (4) to fender

(1). Discard self-locking nuts.

3. Remove rear step (4) from trailer.

INSTALLATION

1. Position rear step on trailer frame and align five mounting holes of the rear step (4) and fender (1).

2. Install five bolts (2) ten flat washers (3), and five new self-locking nuts (5) that secure the rear Step

(4) to fender (1). Do not tighten bolts.

3. Install two bolts (2), four flat washers (3), and two new self-locking nuts (5) to secure rear step (4) to

trailer frame.

4. Tighten all bolts.

4-19 ACCESSORY BOX MAINTENANCE.

c. Installation

This task covers: a. Removal

b. Repair

INITIAL SETUP

Materials/Parts

Tools

Nuts, Self-locking

Tool Kit, General Mechanic's

Rivets, Blind Head

Washers, Lock (item 1, appendix I)

Drill, 1/4-inch (item 2, appendix B)

Riveter, Blind Head

Equipment Conditions

Reference

Trailer support devices are

lowered, paragraph 2-3.2.1.

REMOVAL

1. Release clamping catches (1, figure 4-18) and open accessory box cover (4).

2. Remove any stored accessories from accessory box (5).

NOTE

The 1 ton trailer uses four mounting screws. Also, accessory box mounting hardware

for PU-801A trailer (plain nuts, lock washers, flat washers, and cap screws) differs

from that used on other trailers, but removal and installation procedures are similar.

3. Remove five self-locking nuts (8), flat washers (2 and 7), and bolts (3) that secure accessory box (5) to

trailer chassis (6).

Change 3