Section III. UNIT LUBRICATION

TM 9-6115-661-13&P

Section III. UNIT LUBRICATION

4-7 POWER UNIT/POWER PLANT LUBRICATION.

Refer to LO 9-6115-643-12 for generator set and TM 9-2330-205-14&P for 2 1/2 ton trailer. For 1 ton

trailer lubrication, refer to TM 9-2330-202-14&P. For high mobility trailer lubrication, refer to

TM 9-2330-392-14&P. The rear leveling-support jack is a modification to the standard 1 ton and high

mobility trailer chassis, Lubrication of this leveling-support jack is not covered in these trailer manuals.

Refer to Figure 4-3 and lubricate the leveling-support jack semiannually, as follows.

Dry cleaning solvent used to clean parts is potentially dangerous to

personnel and property, Clean parts in a well-ventilated area, Avoid

inhalation of solvent fumes. Wear goggles and rubber gloves to protect

eyes and skin. Wash exposed skin thoroughly, Do not smoke near

solvent nor use near open flame or excessive heat. Failure to observe this

warning can cause severe personnel injury and/or death.

a. Clean the lubrication fitting (1) with dry cleaning solvent (item 1, appendix E).

b. Inject sufficient GAA grease (item 2, appendix E) into lubrication fitting to lubricate screw threads

(3) inside leg base (4).

c. Apply OE lubricating oil (item 3, appendix E) to both ends of leg prop assembly pivot shaft (2).