CLEANING VEHICLE - continued - TM-9-2320-391-101144

TM 9-2320-391-10

CLEANING VEHICLE - Continued

0091 00

GENERAL - Continued

WARNING

Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear

protective goggles and gloves; use only in well-ventilated area;

avoid contact with skin, eyes, and clothes, and do not breath

vapors. Keep away from heat or flame. Never smoke when using Dry

Cleaning Solvent; the flashpoint for Type I Dry Cleaning Solvent is

100 F (38 C) and for Type II is 138 F (50 C). Failure to comply

may result in serious injury or death to personnel.

If personnel become dizzy while using Dry Cleaning Solvent

(P-D-680), immediately get fresh air and medical help. If Dry

Cleaning Solvent contacts skin or clothes, flush with cold water. If

Dry Cleaning Solvent contacts eyes, immediately flush eyes with

water and get medical attention. Failure to comply may result in

serious injury or death to personnel.

CAUTION

Do not wipe dirt off vehicle when it is dry. Dirt, stones, or debris may scratch

and damage vehicle. Failure to comply may result in damage to equipment.

Use caution when washing around the engine compartment to prevent

damage to sensors and inadvertent removal of grease in bearing surfaces.

Failure to comply may result in damage to equipment.

Periodically wash the engine side of the fan clutch in the engine

compartment. Fine particles of road debris may accumulate in the fan clutch

housing causing the fan clutch to drag and not fully release. Failure to comply

may result in damage to equipment.

Do not allow water to enter air cleaner inlet while washing vehicle. Air

cleaner becomes restricted when wet and may cause a loss in engine power.

Failure to comply may result in damage to equipment.

Do not use high pressure water or steam on starting motor. When cleaning

engine/transmission, starting motor must be protected from any high

pressure water or steam. Failure to comply may result in damage to

equipment.

Do not use high pressure water or steam on remote IGN, ST, or BATT

switches. When cleaning engine, remote IGN, ST, and BATT switches must

be protected from any high pressure water or steam. Failure to comply may

result in damage to equipment.

0091 00-2