Quantcast Bearings

 

Click here to make tpub.com your Home Page

Page Title: Bearings
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Castings
Up
/.5ton/TM-9-2320-386-24-1-2 Extended Service Program (ESP) for 2-1/2-Ton 6x6 M44A3 Series Trucks (Diesel) Manual
Next
INSPECTION - TM-9-2320-386-24-1-20655
TM 9-2320-386-24-1-2
0383 00
GENERAL MAINTENANCE PROCEDURES (Contd)
h. Bearings.
(1) Bearings require special cleaning. After removing surface oil and gum deposits, wipe bearings
dry; do not use compressed air. After cleaning, coat bearings with oil, wrap, and hold for
inspection.
(2) Refer to TM 9-214 for more information on care of bearings.
i.
Machine Tooled Parts.
WARNING
Skysol-100 mixture is combustible. Use mechanical ventilation whenever
product is used in a confined space, is heated above ambient
temperatures, or is agitated. DO NOT use or store near heat, sparks,
flame, or other ignition sources. Keep container sealed when not in use.
Contact with Skysol-100 may cause skin irritation. Use chemical resistant
gloves. In case of skin contact, remove any contaminated clothing and
wash skin thoroughly with soap and water. Wash contaminated clothing
before reuse. Eye contact may cause irritation, tearing, or blurring of
vision. Use face shield or goggles when eye contact may occur. In case of
eye contact, flush eyes with large amounts of water for at least fifteen
(15) minutes or until irritation subsides. Inhalation may cause irritation
to upper respiratory passages. DO NOT have food or drink in the vicinity.
Compressed air source will not exceed 30 psi (207 kPa). When cleaning
with compressed air, eyeshields must be worn. Failure to do so may result
in injury to personnel.
Clean with Skysol-100 and dry with compressed air.
j.
Machined Surfaces. Clean with Skysol-100 and dry with lint-free cloth.
k. Mated Surfaces.
WARNING
Eyeshields must be worn when cleaning with a wire brush. Flying
rust and metal particles may cause injury to personnel.
Remove old gasket and/or sealing compound using wire brush and Skysol-100.
l.
Rusted Surfaces.
NOTE
All parts subject to rusting must be lightly oiled and wrapped
before being stored.
Clean all rusted surfaces using wire brush and crocus cloth.
m. Oil-Bathed Internal Parts. Wipe clean with lint-free cloth.
n. Air-Actuated Internal Parts. Wipe clean with lint-free cloth.
o. Externally Exposed Parts. Wash with soap and water. Rinse thoroughly and air dry.
0383 00-3

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business