STE/ICE-R WIRING HARNESS REPLACEMENT - continued

TM 9-2320-386-24-1-2

0331 00

STE/ICE-R WIRING HARNESS REPLACEMENT (Contd)

16.

Remove nut (5), lockwasher (4), STE/ICE-R terminal lead 770-R (2), and wiring harness terminal

lead 54A (1) from post (3). Discard lockwasher (4).

17.

Disconnect STE/ICE-R harness connector plug (24) with leads 770-F, 770-G, 770-U, and 770-V,

from fuel pressure sender connector (23).

18.

Remove locknut (22), lockwasher (21), clamp (20) with STE/ICE-R wiring harness (13), and engine

ground (GND) harness terminal (19) from stud (6). Discard lockwasher (21) and locknut (22).

NOTE

If quick-start bracket is mounted on engine, perform step 19 to

access wiring harness clamps.

19.

Remove four screws (8), lockwashers (9), ground strap (15), lockwasher (14), and quick-start

bracket (11) from engine (10). Discard lockwashers (9) and (14).

20.

Remove locknut (18) and clamps (7) and (17) with STE/ICE-R wiring harness (13) and engine

wiring harness (16) from stud (12). Discard locknut (18).

21.

Loosen two clamps (25), and remove exhaust flex elbow (26) with gaskets (28) and (29) from

turbocharger (27) and inlet on exhaust pipe (30). Discard gaskets (28) and (29).

22.

Remove tiedown straps (35) from STE/ICE-R wiring harness (13) as necessary to separate STE/ICE-R

wiring harness (13) from other wiring harness. Discard tiedown straps (35).

23.

Remove locknut (36), screw (38), and clamp (37) from STE/ICE-R wiring harness (13) and

bracket (39). Discard locknut (36).

24.

Remove locknut (33), screw (31), and clamp (32) from firewall (34) and STE/ICE-R wiring

harness (13). Discard locknut (33).

0331 00-6