 |
|||
|
|
|||
|
Page Title:
FRONT WIRING HARNESS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0330 00
FRONT WIRING HARNESS REPLACEMENT (Contd)
40.
Install leads 57A (35) and 770-R (36) on fuel shutoff solenoid terminal (38) with new lockwasher (34)
and nut (33).
41.
Install ground (GND) lead (2) on fuel shutoff solenoid terminal (1) with new lockwasher (3) and
nut (4).
42.
Position clamp (30) on wiring harnesses (29) and (37) and install ground (GND) lead (39) and
clamp (30) on mounting stud (7) with new lockwasher (31) and nut (32).
43.
Connect oil pressure sender lead 36 (5) to oil pressure transducer (6).
44.
Position clamp (12) on wiring harnesses (29) and (37) and position clamp (27) on magnetic speed
sensor lead with plug (25). Install clamps (12) and (27) on mounting stud (13) with new locknut (28).
NOTE
If quick-start bracket was mounted on engine, perform step 45 to
replace quick-start bracket.
45.
Install quick-start bracket (10), new lockwasher (14), and ground strap (15) on engine (11) with four
new lockwashers (9) and screws (8).
46.
Connect wiring harness plug with leads 429 and 428 (26) to magnetic speed sensor plug (25).
47.
Connect plug with leads 569 and 569B (17) to quick-start unit connector (16).
48.
Position clamp (18) on wiring harness (24) and on neutral safety switch leads (22). Install
clamp (18) on transmission shift lever (20) with screw (19) and new locknut (21).
49.
Connect wiring harness leads 74A and 74B (23) to two neutral safety switch leads (22).
9
5
2
3
4
8
6
10
11
7
1
13
12
14
38
37
39
15
16
36
17
30
33
35
19
18
31
34
32
20
29
27 26
25
28
24
21
23
22
0330 00-26
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version