 |
|||
|
|
|||
|
Page Title:
AIR INLET ELBOW, MANIFOLD COVER, AND MANIFOLD REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0316 00
AIR INLET ELBOW, MANIFOLD COVER, AND MANIFOLD REPLACEMENT (Contd)
REMOVAL
NOTE
Ensure surge tank is empty.
1.
Loosen clamp (3) and remove hose (4) from fitting (2).
2.
Remove four locknuts (9), screws (6), washers (7), and surge tank (1) from bracket (5) and
bracket (8), and move tank (1) off to side. Discard locknuts (9).
NOTE
Air inlet elbow, manifold cover, and manifold are removed as a
unit.
3.
Remove two screws (11), washers (12), and heater hose clamps (13) from cover (10).
4.
Disconnect fan actuator air line (14) from thermostatic switch (15).
5.
Remove screw (18), washer (19), and clamp (17) with line (16) from fuel outlet manifold (26).
6.
Remove line (16) from connectors (21) and (23).
7.
Remove connectors (21) and (23) from governor (25) and air inlet manifold ports (24).
8.
Remove two O-rings (20) and O-rings (22) from connectors (21) and (23). Discard O-rings (20)
and (22).
9.
Remove fifteen screws (39), washers (38), five screws (29), washers (28), screw (34), and washer (35)
from air inlet manifold (27) and cylinder head (37).
10.
Remove air inlet manifold (27) and gasket (36) from cylinder head (37). Discard gasket (36).
11.
Remove three plugs (31), O-rings (30), plug (32), and O-ring (33) from air inlet manifold (27).
Discard O-rings (30) and (33).
0316 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version