Quantcast CRANKSHAFT REAR SEAL COVER MAINTENANCE - continued - TM-9-2320-386-24-1-20159

 

Click here to make tpub.com your Home Page

Page Title: CRANKSHAFT REAR SEAL COVER MAINTENANCE - continued
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
CRANKSHAFT REAR SEAL COVER MAINTENANCE
Up
/.5ton/TM-9-2320-386-24-1-2 Extended Service Program (ESP) for 2-1/2-Ton 6x6 M44A3 Series Trucks (Diesel) Manual
Next
CRANKSHAFT REAR SEAL COVER MAINTENANCE - continued - TM-9-2320-386-24-1-20160
TM 9-2320-386-24-1-2
0306 00
FRONT ENGINE MOUNTING PAD REPLACEMENT (Contd)
REMOVAL
1.
Remove four screws (7) and washers (8) from oil pan (3) and cover (4).
2.
Remove eight screws (5), washers (6), and cover (4) from cylinder block (1).
CLEANING AND INSPECTION
WARNING
Skysol-100 mixture is combustible. Use mechanical ventilation whenever
product is used in a confined space, is heated above ambient
temperatures, or is agitated. DO NOT use or store near heat, sparks,
flame, or other ignition sources. Keep container sealed when not in use.
Contact with Skysol-100 may cause skin irritation. Use chemical resistant
gloves. In case of skin contact, remove any contaminated clothing and
wash skin thoroughly with soap and water. Wash contaminated clothing
before reuse. Eye contact may cause irritation, tearing, or blurring of
vision. Use face shield or goggles when eye contact may occur. In case of
eye contact, flush eyes with large amounts of water for at least fifteen
(15) minutes or until irritation subsides. Inhalation may cause irritation
to upper respiratory passages. DO NOT have food or drink in the vicinity.
1.
Clean cover (4) with Skysol-100 and dry with lint-free cloth.
2.
Inspect cover (4) for cracks, breaks, gouges, and damaged threads. Replace cover (4) if cracked,
broken, gouged, or threads are damaged.
3.
Inspect mounting pins (2) for wear or fatigue. Replace mounting pins (2) if damaged.
INSTALLATION
1.
Apply sealing compound to mating surfaces of oil pan (3) and cover (4).
2.
Install cover (4) on cylinder block (1) with eight washers (6) and screws (5).
3.
Install cover (4) on oil pan (3) with four washers (8) and screws (7). Tighten screws (7) 21-25 lb-ft
(29-34 Nm).
4.
Install crankshaft rear seal (WP 0305 00).
5.
Install flywheel housing (WP 0307 00).
0306 00-2

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business