 |
|||
|
|
|||
|
Page Title:
CYLINDER HEAD (IN-VEHICLE) MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0302 00
CYLINDER HEAD (IN-VEHICLE) MAINTENANCE (Contd)
54.
Remove two screws (39) from oil drain tube (38).
55.
Remove four locknuts (40) and turbocharger (20) with oil drain tube (38), gasket (41), and O-ring (37)
from exhaust manifold (36) and engine (1). Discard locknuts (40), gasket (41), and O-ring (37).
56.
Bend tabs of five retaining rings (34) and retaining ring (43) from heads of twelve screws (42), and
remove screws (42), retaining rings (34) and (43), exhaust manifold (36), and three gaskets (35) from
engine (1). Discard retaining rings (34) and (43) and gaskets (35).
57.
Disconnect fuel line (46) and O-ring (45) from elbow (44) at rear of engine (1). Discard O-ring (45).
58.
Remove locknut (51), ground (GND) strap (50), and lockwasher (49) from stud (47) on firewall (48).
Discard locknut (51) and lockwasher (49).
59.
Remove screw (58), washer (57), clamp (56) with breather tube (59), and spacer (60) from engine (1).
60.
Remove two screws (55), washers (54), screws (61), washers (62), and crankcase breather base (53)
with breather tube (59) and gasket (52) from engine (1). Discard gasket (52).
1
1
35
34
35
~
~
43
42
41
44
40
45
37
20
46
36
38
39
52
53
47
48
~
54
55
49
~
56
50
62
61
57
1
51
60
58
59
0302 00-13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version