 |
|||
|
|
|||
|
Page Title:
ENGINE REAR MOUNTING PADS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0300 00
ENGINE REAR MOUNTING PADS REPLACEMENT (Contd)
REMOVAL
1.
Remove four locknuts (3), screws (4), and rear of front propeller shaft (2) from transfer case
flange (1). Discard locknuts (3).
2.
Swing rear of front propeller shaft (2) toward passenger side of vehicle and secure it to underside of
vehicle to provide room for transmission jack.
3.
Remove two locknuts (16), washers (15), and screws (19) from engine mounts (10) and (20) and
mounting brackets (13) and (21). Discard locknuts (16).
4.
Install chain on lifting eye (9) with two washers (7), screw (6), and nut (8).
WARNING
Lifting device must have a weight capacity greater than the
weight of the engine and transmission to prevent injury to
personnel and damage to equipment.
Do not put hands between engine mounts and rubber mounting
pads when removing mounting brackets. Lifting device or jack
failure may cause injury to personnel.
CAUTION
Do not raise engine more than 0.5 in. (13 mm). Failure to comply
may result in damage to transmission, radiator, or related parts.
5.
Connect chain to lifting device.
6.
Raise engine (5) until there is space between engine mounts (10) and (20) and rubber mounting
pads (12) on left and right sides of frame (18).
7.
Position transmission jack under transmission lifting point and raise jack just enough to support
transmission.
8.
Remove two washers (11) from mounting brackets (13) and (21) on left and right sides of frame (18).
9.
Remove eight locknuts (14), screws (17), and mounting brackets (13) and (21) from left and right
sides of frame (18). Discard locknuts (14).
10.
Remove two mounting pads (12) from mounting brackets (13) and (21).
0300 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version