 |
|||
|
|
|||
|
Page Title:
HEADLIGHTS AND HEADLAMPS MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0107 00
HEADLIGHTS AND HEADLAMPS MAINTENANCE (Contd)
ALIGNMENT
NOTE
Perform headlamp alignment for both headlamps.
Perform follow-on-task prior to headlight alignment.
1.
Using chalk, draw a horizontal line (5) on a wall at the height of 3.25 ft (1 m).
2.
Position truck facing wall so headlamps (2) are 25 ft (7.6 m) from wall.
3.
Using chalk, draw a vertical line (7) through horizontal line (5) so it is in line with center of each
headlamp (2).
NOTE
Turn headlamps on low beam (TM 9-2320-386-10) as necessary to
check alignment.
Once retaining ring is removed, the headlamp must be supported
on the headlight fixture. Electrical wires are not intended to
support the weight of the headlamp.
4.
Remove three screws (4) and retaining ring (1) from headlight (3).
5.
Adjust headlamp (2) horizontal direction with adjusting screw (9) until left edge of light area (6) on
wall is 2-6 in. (5-15 cm) right of vertical line (7).
6.
Adjust headlamp (2) vertical direction with adjusting screw (8) until top edge of light area (6) on
wall is touching lower side of horizontal line (5).
7.
Install retaining ring (1) on headlight (3) with three screws (4).
8.
Connect battery ground cable (WP 0121 00).
3
2
1
4
0107 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version