Table 2. STE/ICE-R GO-Chain Tests - continued

TM 9-2320-386-24-1-1

0016 00

Table 2. STE/ICE-R GO-Chain Tests (Contd)

NOTE

Test G01, VTM Connections and Checkout, must be

performed before running any other STE/ICE-R test.

DCA

CHARGING CIRCUIT AND BATTERY VOLTAGE TEST

G04

MODE

SET ENGINE RPM:

TEST NO.

TEST

Run vehicle at 1200-1400 RPM.

Turn vehicle headlights and accessories ON to load

BATTERY VOLTAGE

charging system.

MEASURE BATTERY VOLTAGE:

NOTE

Dial 67 into TEST SELECT and press TEST.

After completing repair, rerun the GO-

Watch display and verify that battery voltage is

Chain tests to verify that the problem is

within 26.5-29.5 volts.

fixed and that no other problems exist.

Is battery voltage within limits?

YES

Is battery voltage low?

Battery voltage is high.

Refer to Electrical Troubleshooting

YES

(WP 0011 00) to troubleshoot

regulator and wiring.

Battery voltage is low.

Allow vehicle to run for 5 minutes at 1200-

1400 RPM and watch the display.

Is the battery voltage within limits?

YES

Turn off headlights and accessories.

Turn vehicle engine off.

Proceed to Charging Circuit Tests,

NG50.

Proceed to next page.

NG50

0016 00-12