Click here to make tpub.com your Home Page

Page Title: PARKING AND SERVICE BRAKESHOE REPAIR - continued
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-361-24-2
0457 00
PARKING AND SERVICE BRAKESHOE REPAIR (Contd)
NOTE
Parking and service brakeshoes are repaired basically the
same. This task covers service brakeshoe repair.
All service and parking brakeshoe linings must be replaced as
matched sets.
DISASSEMBLY
Remove fourteen rivets (4) and lining (2) from service brakeshoe (1). Discard rivets (4).
CLEANING AND INSPECTION
WARNING
Do not use a dry brush or compressed air to clean brakeshoes.
There may be asbestos dust on brakeshoes, which can be
dangerous to your health if you breathe it. (Brakeshoes must
be wet and a soft bristle brush must be used).
Skysol 100 solvent is combustible; DO NOT use or store near
heat, sparks, flame, or other ignition sources. Use mechanical
ventilation whenever product is used in a confined space,
heated above ambient temperatures, or agitated. Keep
container sealed when not in use.
Contact with Skysol 100 may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap
and water. Wash contaminated clothing before reuse. Eye
contact may cause irritation, tearing, or blurring of vision. Use
face shield or goggles when eye contact may occur. In case of
eye contact, flush eyes with large amounts of water for at
least 15 minutes or until irritation subsides. Inhalation may
cause irritation to upper respiratory passages. DO NOT have
food or drink in the vicinity. Failure to comply may result in
injury to personnel.
1.
Clean brakeshoe (1) with water and soft bristle brush. Allow to air dry. Clean with Skysol 100.
2.
Check brakeshoe (1) for cracks, warps, flat spots on faces, and out-of-round rivet holes (3). Replace
if cracked, warped, flat, or holes are out-of-round.
ASSEMBLY
1.
Install new lining (2) on service brakeshoe (1) with fourteen new rivets (4).
2.
Install parking or service brakeshoes (WP 0164 00 or WP 0167 00).
0457 00-2

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business