 |
|||
|
|
|||
|
Page Title:
PERSONNEL HEATER FLAME DETECTOR SWITCH MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0431 00
PERSONNEL HEATER FLAME DETECTOR SWITCH MAINTENANCE (Contd)
REMOVAL
NOTE
Prior to removal, tag lead wires for installation.
1.
Remove two screw-assembled lockwashers (8) and ignition control leads (4) from flame detector
switch (7). Discard screw-assembled lockwashers (8).
2.
Remove screw-assembled lockwasher (1) and blower motor lead (9) from flame detector switch (7).
Discard screw-assembled lockwasher (1).
3.
Remove two screw-assembled lockwashers (2) and receptacle leads (3) from flame detector
switch (7). Discard screw-assembled lockwashers (2).
4.
Loosen nut (6) and remove flame detector switch (7) from heater housing (5).
DISASSEMBLY
1.
Remove adjusting screw (10), washer (11), and spring (17) from microswitch (12) and mount (13).
CAUTION
Ceramic rod is very brittle and is easily broken; handle
carefully. Failure to comply may result in equipment damage.
2.
Tilt microswitch (12) back on mount (13).
3.
Invert microswitch (12) and remove ceramic rod (18) from probe (14).
4.
Remove nut (15) and sleeve (16) from probe (14).
CLEANING AND INSPECTION
Inspect flame detector switch (7) for oxidation and dirt, broken ceramic rod (18), and bent or distorted
probe (14). If oxidized or dirty, clean by removing ceramic rod (18) and lightly rapping side of probe (14)
to loosen oxides and dirt. Replace flame detector switch (7) if ceramic rod (18) is broken or probe (14) is
damaged.
ASSEMBLY
CAUTION
Ceramic rod is very brittle and is easily broken; handle
carefully. Failure to comply may result in equipment damage.
1.
Tilt microswitch (12) back on mount (13) and insert ceramic rod (18) in probe (14).
2.
Position spring (17) in place and tilt microswitch (12) back into position.
3.
Install washer (11) and adjusting screw (10) until microswitch (12) clicks, then continue an
additional 3/4 turn.
4.
Install sleeve (16) and nut (15) on probe (14).
INSTALLATION
1. Install flame detector switch (7) on heater housing (5). Tighten nut (6).
2.
Install receptacle leads (3) on flame detector switch (7) with two new screw-assembled
lockwashers (2).
3.
Install blower motor lead (9) on flame detector switch (7) with new screw-assembled
lockwasher (1).
4.
Install ignition control leads (4) on flame detector switch (7) with two new screw-assembled
lockwashers (8).
5.
Install personnel heater guard (WP 0427 00).
6.
Connect battery ground cable (WP 0126 00).
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0431 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version